Makita DMR110 Li-ion DAB/DAB+ Job Site Radio - Batteries and Charger Not Included

Product Information

Connect a stereo or mono source (i.e. iPod, MP3, or CD player) to either AUX IN 1 or AUX IN 2 by audio cord. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. It may result in loss of your eyesight.

DAB display: station name, program type, multiplex name, time/date, frequency, bit rate/audio type and signal strength Reduced power, distortion and a "stuttering sound" are signs that the battery needs to be replaced.Press and hold the desired Preset button until the preset number shown on the display, for example, "P2 Saved". The station is then stored in the selected Preset button. Rotate the Volume/Tuning Control/Select knob until "Factory Reset" shown on the display. Press the Volume/Tuning Control/Select knob to enter the setting.

When using FM mode, your radio can be set to scan either local stations or to scan all stations including distant radio stations. Manual Tuning – FM Batteries: 7.2v Cluster / 10.8v/12v Max CXT / 14.4v/18v LXT Li-Ion Batteries (Excluding Makita 'G' Batteries) Rotate the Volume/Tuning Control/Select knob to select the following options and press the knob to confirm the setting.Rotate the Volume/Tuning Control/Select knob to scroll through the list of available stations. Press the knob to select the station. Keep rotating the Volume/Tuning Control/Select knob until desired frequency is shown on the display. Rotate the Volume/Tuning Control/Select knob to choose your desired language. Press the Volume/ Tuning Control/Select knob to confirm your setting.

Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. For preparation of the item being shipped, consulting an expert for hazardous material is required. Please also observe possibly more detailed national regulations. If operating time has become excessively shorter, stop operating immediately. It may result in a risk of overheating, possible burns and even an explosion.

You may also be interested in...

Repeatedly press and release the Band button until "AU1" or "AU2" is displayed, then AUX function is activated.

Manual tuning allows you to tune your radio to a particular DAB frequency in Band III. This function can also be used to assist the positioning of the antenna or the radio so as to optimize reception for a specific channel or frequency. Select the desired waveband by pressing the Band button. Make sure the soft bended rod antenna has been well placed for best FM reception. Try to avoid operating the radio next to a computer screen and other equipment which will cause interference to the radio. In this guide, you will find all the information you need to install the new software. System requirementsRotate the Volume/Tuning Control/Select knob to choose "Yes". Press the Volume/Tuning Control/ Select knob to confirm the setting and a full reset will be performed.